Jump to content
Sign in to follow this  

Won't Start ???

Recommended Posts

I just put in a set of stock intake valves and everything seemed to be fine. Bike went together fine. Valves are right on spec. Bike just wont fire up. I can bump start it but can't kickstart it. It also doesn't want to hold the idle either. After about 5 kicks or so it backfires then back to nothing. What gives :thumbsup:

Share this post


Link to post
Share on other sites

The piston is at TDC. Both the cam sprocket and the side case alignment are right on. Is there anyway else it could be out of time?

Share this post


Link to post
Share on other sites

Checked the decomp clearance. It was at .025. Way outa tolerance. I'll see if this works. Any other suggestions???

Share this post


Link to post
Share on other sites

Did you have the carb apart? There are 2 pieces to the slide and if the small flat piece is upside down it won't run right at all. If you didn't take it apart take a long hard look at the timing.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×