Jump to content
Sign in to follow this  

question for JD

Recommended Posts

Im in Australia and would like to get a jd jetting kit what is the best way also its for a kx250f my bike was running fine until my last ride i washed it went to start it and it wouldnt idle it was popping with a little bit of throttle checked the valves they were fine my jetting was 180 main 42 pilot 4th clip pos from top with obeks neddle and 2 and a half turns on the fuel screw so i went to a 45 pilot and the 5th neddle position and about 3 and a half turns on the fuel screw and it runs ok we are heading into summer over here and want to get the jetting set perfect im on about no more than 800 ft above sea level temps will be in the hundreds hum in the 90s any help would be good thanks

Share this post


Link to post
Share on other sites

The jeting kit can be ordered by picking the banner ad above. It comes with installation and setup instructions.

Thanks,

James

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×