Jump to content
Sign in to follow this  

Seating new rings

Recommended Posts

Depending on the condition of your plating/cylinder a shop that has the proper diamond honing tools can do a proper job of touching up your plated cylinder. In a lot of cases on a newer motor it should be OK. I had mine done for cheap insurance to clean up the crosshatch. Don't try it as stated above with standard honing tools as the coating is too hard :cry:

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×