Jump to content
Sign in to follow this  

How to make the Kawasaki fork tool.

Recommended Posts

Go to the local hardware store and purchase the following: (or dig in your junk bin)

1 pc of 1/2 pipe 10" long minimum

1 steel pipe fitting that has a 7/8" hex on the outside (a 7/8 wrench fits it and has a 3/8 pipe minimum inside diameter)could be a 3/8 by 1/2 reducing nipple

Any fitting with a hex that will screw onto the other end of the pipe.

Assemble the pieces and weld together so they won't turn. Clean thoroughly before using. The 7/8 hex end goes down in the fork to hold the inner piece from turning while you remove the bottom bolt. The hex on the other end of the pipe is for a wrench. :cry:

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×