xr 650 2002

ok here is the problem,my father in law bought a new xr 650 and had the hot kit put on it, the thing is , it starts great when its cold but once you start it and if you happen to stall it the thing wont fire. we would clear the thing and it would fire with the choke on but as soon as you would take the choke off to kick it it would flood and drain out the bottom. we must have kick the thing 50 times. what could be the problem? could the float be stuck?

I assume that you talking about the "power up Kit" (Competition needle, main jet, intake manifold, etc.)?

Did you install new exhaust or the competition baffle?

Did you remove both air box plugs?

I have experienced a problem with mine when it was getting more air than it needed and would only run on half choke.

I am no expert though.

Thanks for the correction. So many people call it different things.

Originally posted by PowerCell:

That's the "Full Power Kit". The Power-Up kit is H/C piston, Cam, HD cam chain, etc.

The full Power Up Kit PN# is "06130-NLB-010" and includes the following components.

Gasket, Right Cover

Gasket, Cylinder

Gasket, Cylinder Head


Piston Ring Set

Piston Pin

Clip, Piston Pin

Camshaft Assy.

Sprocket, Timing

Sprocket, Cam

Chain, Cam

Guide, Cam chain

Tensioner, Cam Chain

Lifter Assy, Tensioner

Gasket, Tensioner Lifter

Spring, Clutch

Spark Plug R7113-10

Spark Plug R7113-9

Rubber, Stud

Bolt, Flange 6x25

Needle Jet set

Jet, Main # 180

Jet, Main # 182

Jet, Main # 185

Jet, Main # 188

Jet, Main # 190

Here's a picture of it...


Thanks qadsan! I was currious as to exactly what came in the kit. Pretty dam complete I'd say...

That's the "Full Power Kit". The Power-Up kit is H/C piston, Cam, HD cam chain, etc.

That's the "Full Power Kit". The Power-Up kit is H/C piston, Cam, HD cam chain, etc.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Similar Content

    • By Jeremy Evans
      I just bought a 2012 xr650l and it starts and runs great until about 4000 rpm give or take (I’m guessing) it feels like it spits and pukes. Also when releasing the throttle the exhaust pops and hiccups. I am calling the dealership to ask if they are willing to fix the problem as I just purchased from them yesterday but I am curious as to what the problem could be in case they do not offer to help for my “as is” purchase. I have read a couple other topics on here that talk about the vacuum lines being hooked up to an air cut diaphram but I don’t know what that is. The smog delete has been done on this bike as well as a slip on dg exhaust and the side cover has a bunch of holes drilled in it exposing the air filter. The battery has also been relocated. My question is what jetting should I have at 2000 feet? I am planning on opening up the carb to see what the idle jet and main jet are and if they were even changed from stock. Also if someone knows about the air cut being hooked up to vacuum and can supply pictures that would be very helpful. I know that the smog block off kits just plug the vacuum holes and the air cut usually gets disconnected. Thanks. 

    • By Chowell
      Cargo rack for Honda XR650l.
      New condition. No scratches or damage. New $199 
      See manufacturers website for detail.
    • By Pcolamotorhead
      engine parts and misc. parts. Airbox, Electronics, Brake parts.
    • By Pcolamotorhead
      Parting out almost an entire bike. Frame is gone, CDI box, and Wheels, Gas Tank, Headlight & Front number plate. Complete unassembled engine with 9611 miles on it. 90 pounds of compression at cranking speed. According to hondaprokevin.com this is what it should have.  Checked the compression with 3 different gauges.   Valve clearance is good which indicates no cam or rocker arm wear. Oil did not look too bad that came out of it. Corbin seat, Big tube header pipe with Super trap muffler, and just about all the other parts.  Shoot me a message with what you are looking for and I will be happy to take pics and send them to you along with a price. All items are buyer pays the shipping.  Also have some 1996 Honda XR600R parts. Engine cases, Electronics, Etc.  $850 for the motor and you pay shipping, Starter motor not included.