Jump to content
Sign in to follow this  

swingarm bearing re-pack

Recommended Posts

I finally got my swingarm bolt out (needed a bigger hammer). My question is about greasing the bearings... do I dis-assemble all the parts (e.g. rubber seals, washers, individual needle rollers) before I grease, or just smear grease all around (without dis-assembly) and call it good to go? Anything to watch out for? Thanks in advance.

Share this post


Link to post
Share on other sites

Remove the parts that remove by hand. Do not pry seals out or press bearings out. In the swing arm, you remove the outer seal spacers and the inner bearing sleeves. Inspect parts for condition. Pack with grease and reassemble. Careful of seal lips.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×
×
  • Create New...