bluerock5 Posted December 15, 2004 I put on a new Renthal Handlebar and the Horn/Hi-low Beam control by the clutch lever has a pin on it that fit into a hole on the orginal handlebar - and the new handle bar does not have one - is it OK to just cut off the pin so it fits flush or should I drill a hole in the new handlebar to sink the pin into. Thanks Share this post Link to post Share on other sites
Beerad Posted December 15, 2004 do not drill the handlebar, you can shave the pin down with a file and just leave a little bit of it, maybe a 1/16 or so, this will help keep it tight. Share this post Link to post Share on other sites