Jump to content

Engine skipping


Recommended Posts

I have a 2000 DRZ400E. After riding about 2 miles, the bike begins to start skipping. I have replaced the plug, had the carb gone through, drained gas in fuel tank, cleaned petcock, checked all electrical connections and grounds, checked valve clearance, and had coil tested for 15 minutes. I don't want to throw parts at it...that gets too expensive. Does anyone have any ideas on what the problem could be???

Link to comment
Share on other sites

The sending coil is built into the stator, you test it by using an ohm meter on the plug at the CDI box. Test each wire in the plug to ground, there should be no continuity, i.e. open circuit. Then test between the wires, 2 are for the sending coil and 2 for the pickup coil, they should show low resistance.

Link to comment
Share on other sites

if they didnt there would be tons of blown up drz's.

its just higher on a E.

So......I can ride it harder?? Here I thought I was giving it hell...I didnt even know it has a rev limiter, must not be giving it enough hell.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

×
×
  • Create New...