Jump to content
Sign in to follow this  

250x bogs in the middle:jd kit

Recommended Posts

just put the jd kit in as per instructions for 1500 ft. red needle 3rd position, stock pilot, zip ty 2 turns, 150 main. backfire screen out and airbox slightly cut. stock exhaust. starts and runs fine but when rode hard in the middle it bogs a bit. any advice plz> thanks Bill

Share this post


Link to post
Share on other sites

Bill,

None of your settings match the instructions, Why?

The kit instructions say to use the 5th from top clip position. Move the clip from 3rd to 5th position from top and ride it to test.

Set the fuel screw to 2 1/4 turns and run a #158 main jet per the instructions.

Thanks,

James

Share this post


Link to post
Share on other sites

yeah man you are correct. dont know where i got what i did. thanks for the reply, went back and did it the right way and now all is warm and glowy in my little bike world. ~bill

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×