Jump to content
Sign in to follow this  

03-250F Intake Valves

Recommended Posts

I've found lots of threads discussing valve clearance, etc..I'd like to understand a bit more how performance may be impacted when running the intake valves .001 - .002" above spec limit. My intakes are now set at .007" clearance -vs- the manual saying not to exceed .006"....Setting them to .007 was the only way I could get all three valves with the same clearnace. My assumption is the bike will run better if all 3 intakes are set equally. Any advice as to how this would impact my bikes performance?

thanks again!

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×