Jump to content
Sign in to follow this  

Engine assembly question

Recommended Posts

I'm installing a Hotcams into my engine this coming week and Hotcams says to use assembly lube liberally. I have a Honda product, but it has Moly which I know is not good for wet clutches (which is in an XR400". If I use the lube with Moly will there be any problems? What other products have you guys used when rebuilding top ends?

Share this post


Link to post
Share on other sites

i have a Hotcam, no special requirements i poured 1 cup of oil through the valve adj cover just to make sure it had oil when i fired it up, as far as assembly i used anti seize on all the bolts never had a problem,

run reg motorcycle oil to do the breakin, then you can go back to what you were using . Semie or full synthetic,keep away from moly as you know,

you'll enjoy the cam, :) it wakes up the motor a bit.

stu

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×