Jump to content
Sign in to follow this  

fcr 39

Recommended Posts

hello and thanks

dyno jetted stock carb per tt awesome felt like stud. Just ordered carb parts fcr 39 am I in over my head ?? :)

Share this post


Link to post
Share on other sites

what is your bike? do you have a fcr? DJ kit is for a S model

Share this post


Link to post
Share on other sites

I believe if you put a DJ kit in you have the S model with the mikuni carb, not the FCR. :)

Are you putting the FCR in?

Share this post


Link to post
Share on other sites
hello and thanks

dyno jetted stock carb per tt awesome felt like stud. Just ordered carb parts fcr 39 am I in over my head ?? :)

If you are ordering parts for your S model, you better order mikuni parts, unless it has a FCR. Do you know what carb it has ? S models have Mikuni and e/k modelws have the FCR :)

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

  • Similar Content

    • By smokey9lives
      Hi,
      I have a 2003 DRZ (actually a KLX400) and the head tube bearings are shot.  I ordered a new set to install but I'm wondering if anyone has any recommendations on other parts I should replace while I have the front disassembled.  I was thinking about new rubber fork protectors, but are there other things that wear out on the DRZ front ends that you can only get to when disassambled?
      I also broke off a replacement key that I got for the steering lock.  I must have been made of cheap pot-metal.  Should I just remove the whole lock mechanism?
      Any tips or tricks for getting the old bearings out and the new ones in would be welcome!
      Thanks!
    • By antonyp
      Hey Guys,
      I recently bought a 2003 DRZ400S and thought it would be a good idea to check the valves clearance etc . I timed the engine on TDC with the magneto mark aligned as per the manual but I find the cam timing slightly odd. The arrows pointing upward are on the 1st and 15th pin as they should but with the magneto timing mark aligned they are not perfectly straight. Same goes for the arrows that should be parallel to the cylinder head casing. Is this normal or should they be absolutely perfect ?
       

    • By 4strokeOnly
      My bike was stolen, so I'm liquidating my spare parts. 
      I took this off my S and replaced it with an SM unit so my speed would be more accurate with the street wheel setup.  I no longer need this spare.  I greased it regularly and it was in good working order when I removed it.  Included is only what is pictured.  Cable not included.
      Suzuki part number:  54600-29F00
      buyer pays shipping.
×