Jump to content
Sign in to follow this  

z-start install question??

Recommended Posts

I need help asap, my bike is apart in the garage.

I am installing the rekluse on my 03 crf450. When measuring the space between the friction plates, I am measuring 0.101". The instructions say it should be 0.030-0.042". To make up that gap I will have to put back 4 stock plates to get it to the far end of the tolerance.

I measured a friction plate at 1.16", minimum spec by the owners manual is 1.06".

Has anyone else had to do this? THe directions make it sound like it should only take one stock plate to get back into tolerance

Share this post


Link to post
Share on other sites

nevermind, underdog on the general forum straightened me out. I was measuring between two friction disks instead of a steel plate & friction disk.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×