Jump to content
Sign in to follow this  

Questions about Burneds jetting and exhaust up grades

Recommended Posts

I know the DJ kit was for a bike without the 3x3 mod and Burned has done the work of finding the best combo to add some gas for the 3x3 mod.

My question is if I take the exhaust header off and open up the welds to the ID of the tube and then take the spark arrestor and end cap out entirely and put a little something there to just keep the rain out, how will the updated jetting handle that. Will I have to go up a size or two on the MJ.

Other mods would be the 3x3, a 41 in the back, a small wind screen, a seat instead of a 2x4, hand gaurds, trim the front and rear fender, bar risers or a bar or both.

Share this post


Link to post
Share on other sites

save your self the trouble with the stock head pipe mods, you will just have a louder bike, there is not sufficient room for improvement with the stock header to mess with it, either do the 3x3 with end cap mod or w/o or go ahead and add the a full system like muzzy or yosh. With the stock pipe w or w/o end cap mod run the 140, with the full system run 142.5

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×
×
  • Create New...