Jump to content
Sign in to follow this  

xr 70 throttle spring valve position help

Recommended Posts

I am having trouble seating the plastic tube that houses the needle jet there are a few slits in it and its cut at an angle at the bottom does anywho know the postion i put this in if im installing it from the shifter side looking at the carb??

Share this post


Link to post
Share on other sites
I am having trouble seating the plastic tube that houses the needle jet there are a few slits in it and its cut at an angle at the bottom does anywho know the postion i put this in if im installing it from the shifter side looking at the carb??

OK, I get it now...

The piece you are talking about is metal - it's the slide.

It has a wide ramp cut on one side for the idle adjustment screw and a slot from top to bottom on the other where a pin, inside the bore where it moves, locates it and keeps it from turning.

Share this post


Link to post
Share on other sites

If you are talking about the slide described above then... when working on the carb from the shifter side the long slot in the slide should face directly away from you, towards the brake side. Good luck!

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×
×
  • Create New...