Jump to content
Sign in to follow this  

Graphics

Recommended Posts

What's the best way to get the standard graphics off the tank and rad shrouds? And is there an agreed best way of putting aftermarket ones on - I've read posts which say use contact cleaner, don't use contact cleaner, use soapy water, don't use soapy water etc. All a bit confusing.

Share this post


Link to post
Share on other sites

I just got done refurbing an xr 200. To remove the stickers. I poured domestic hot water over slowly over the sticker I was removing and it worked great. It softens the glue and makes the sticker more pliable. They peeled right off

[This message has been edited by mike68 (edited 12-27-2000).]

Share this post


Link to post
Share on other sites

the graphics on my yz pulled right off like a bad wallpaper job. putting new graphics on this weekend, recommend spraying the graphics and surface to be applied to with mixture of 2/3rds water 1/3rd rubbing alcohol. this allows you to move the graphic around for best alignment and makes it easy to remove air bubbles. use a credit card wrapped with a paper towel to squeege the air bubbles out.

Share this post


Link to post
Share on other sites

Heat guns work well but be careful those things are seriously hot. Hair dryer only as a last resort.

------------------

JJ - 99 WR; WR timed, stock jetting, Scotts stabalizer, Scotts triple clamps, Pro-Tapers, Terry Cable Hot start, MSR Raptor clutch lever, Moose skid plate, Works frame guards, Acerbis Pro Rally guards, Renthal MD-soft grips, Russel speed bleeders, Factory Effect graphics, YZ rear fender

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×