displaynamerequired Posted October 7, 2005 I just got some graphics, is there any liquid I could make to spray on it so they slid on and still stick? Share this post Link to post Share on other sites
CRF230Fmelike Posted October 7, 2005 Soapy water. Apply the graphics into place, then use a hair dryer or sun light to evaporate the water. Share this post Link to post Share on other sites
Valerie Wilson Posted October 7, 2005 In just use windex.!!!!!! Share this post Link to post Share on other sites
displaynamerequired Posted October 8, 2005 Would I have to let the bike sit for a few days so the graphics could dry ? Share this post Link to post Share on other sites
displaynamerequired Posted October 8, 2005 In just use windex.!!!!!! Did you spray it on the graphics or on the plastic and how much did you put on (if you can put to much on)? Share this post Link to post Share on other sites
CRF230Fmelike Posted October 8, 2005 Ive never used the windex trick but with the soapy water just give it some sprays on the clean plastics. You wont do anything by putting "to much" on, it will just take more time to get the water out. Once you spray, align the graphics and slowly start pushing the water out to the edges of the stickers. This still allows you to peel back the decal if you have a bubble, just make sure you spray again if its a tricky area that you are having trouble with. Once you get most of the water out by pushing, either set them in the sun or I use two high powered utility lights to evaporate the rest of the water if ill be riding within a day or two. Share this post Link to post Share on other sites
