YZ front end conversion done. Help please.

[Slayer77]

I just finished the YZ conversion on my TTR. It seems killer but there is one huge bummer. The front end won't seem to line up. It is slightly off to one site. I have a new TAG top clamp for the OS bars and I'm using the stock bottom clamp. The fork legs seems to slide in fine through the clamps.

What could be wrong?

Thanks in advance

[ttr225ttr]

is one side tighter than the other? loosen completely and try again. also check to see if the forks are bent at all

[Slayer77]

Thank you. I did that and it seems that the problem is still going on. Could the lower clamp be bent? The legs seem to go through fine. I don't get it.

Thanks,

[ttr225ttr]

Thank you. I did that and it seems that the problem is still going on. Could the lower clamp be bent? The legs seem to go through fine. I don't get it.

Thanks,

I am not sure but it sounds possible that they are bent I really dont know to much about this but Im just tryin to help. use a level to see if they are bent or just do it by eye and if it not bent are you sure that to forks are the correct year for the mod?

[SCOTTYZF426FLA]

What do you mean it is off to one side? I just did my bike and it came out fine. Is it binding when you push the forks down? If so you need the YZ 80 front axle spacers AND 2 or 3 washers between the spacer and fork leg with out the disk. Try that and let us know what happens...

[28marcb]

Do the yz top clamps line up right?

[Dwillrace]

Loosen the stem nut and the top triple clamp. Align the front. Then tighten the top triple clamp first then the stem nut. This worked for me.

[Slayer77]

Right on... I will try that tomorrow dude... Thank you. Something is up... It still works killer though, just off a bit!!

Thanks,Forrest