Jump to content
Sign in to follow this  

Balancing reciprocating assembly for big bore?

Recommended Posts

Does anyone do this, or are the big bore (436 for use w/the MT setup) slugs the same mass?

Share this post


Link to post
Share on other sites
Does anyone do this, or are the big bore (436 for use w/the MT setup) slugs the same mass?

I could do it for you ... however for what it would cost vs what you would gain ... I would do what Nate said ... Just put it in and run it ... unless you jump off a bone stocker and then onto a big bore ... and were paying attention ... you won't notice the difference ...

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×