substitute circlip?

[redride79]

After breaking a leg at Ponca , Ive been fidgeting with everything I can get my hands on, and in the process of doing a topend on a cr250, While wrestling around too get low enough to install the piston pin cir-clip I let it fly out into the backyard at night. I took the clip out of the stock piston and used it, but it seems a little lighter than the Wisco clip. Should I chance it? I couldn't drive the pin out with it installed. If it was my bike I would try it but I don't know

[ShadyatBest]

if the holes are the same you should be fine. But this is one part that should always be replaced. tis cheap. But this means no finishing the top end tonight

[MRD RACING]

you should measure the wire diameter of the two clips to be sure . sometimes wiseco uses bigger wire , witch would mean a bigger groove than the stock clip is made to fit

[Shawn_Mc]

Ive done some iffy shit when pushed for time..but that I wouldnt do...