Jump to content
Sign in to follow this  

MCCT-Breather box/Oil return tank hose goes ?

Recommended Posts

I had to remove the black box in order to replace the ACCT with a MCCT. While doing so, I ended up pulling the hose that connects to the back of the black box way out. It appears to have come out of where it was connected but I can't figure out where that was. Does anyone know where the hose connects?

garage.php?do=viewattachment&attachmentid=24191

Share this post


Link to post
Share on other sites

It just vents to open air. Stick it back down through the frame like your carb vent hoses run.

Share this post


Link to post
Share on other sites
It just vents to open air. Stick it back down through the frame like your carb vent hoses run.

"Diddo" It just hangs free with the other hoses. Make sure it does not get pinched off.

Share this post


Link to post
Share on other sites
Doesnt that one run to the airboot on an S model?

it does on mine

Share this post


Link to post
Share on other sites
Doesnt that one run to the airboot on an S model?

Yes. And also on the E model.

Share this post


Link to post
Share on other sites
Yes. And also on the E model.

does not run to the air boot on a E model.

only on S/SM and 04 and newer cali E models.

Share this post


Link to post
Share on other sites
It's a 2003 E. What is the airboot?

it runs straight down toward the ground from where it is now.behind the tab on the air box.

Share this post


Link to post
Share on other sites
It's a 2003 E. What is the airboot?

The rubber piece that goes inbetween the airbox and the carb.

Share this post


Link to post
Share on other sites

Thank everyone. I must be getting old because I have been in this area of the bike before quite a bit and it seemed that, from the length, there was no where to connect it but no where that I put it to just hang "looked right." Duh, air boot=air box.

Share this post


Link to post
Share on other sites
air boot=air box.

Not quite, air boot connects to the air box on one end and the carb on the other.

Share this post


Link to post
Share on other sites
does not run to the air boot on a E model.

only on S/SM and 04 and newer cali E models.

You're right - I was looking at the diagram for an 05 Cal spec E

Share this post


Link to post
Share on other sites

Cool...well I will run it to the ground with the vent hoses then. I was at just a bit of a loss what to do with it after I did the FCR coversion.

Share this post


Link to post
Share on other sites
Not quite, air boot connects to the air box on one end and the carb on the other.

got it, thanks much.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×