Jump to content
Sign in to follow this  

is it time?

Recommended Posts

you should pull the head cover off and check the clearances with a feeler gauge. if you own a service manual find out if they have proper clearances. if they do not then use the chart in the service manual to figure out what size shims you need and then replace the old shims. BE CAREFUL TO NOT DROP THE TIMING CHAIN, CLIPS, OR SHIMS INTO THE MOTOR!!! this proccess only takes roughly an hour.

Share this post


Link to post
Share on other sites

Is this thing brand new??

If it's new, I doubt seriously if it needs adjusting.

If it's used, you need to find out where you're at to determine if it needs shimming.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×