Jump to content
Sign in to follow this  

skid plate question

Recommended Posts

i have a works connection skid plate, and my question is about the clamps. i am wondering i have three of the clamps on with no problem but it seems like i have to unmount the engine mounts to put on the clamp on the brake side. the one in the back . any help?

Share this post


Link to post
Share on other sites

I've put three of these on three different motorcycles without having to unbolt anything. Did you put the holding bracket between the frame and motor prior to screwing it into the skid plate? Worse case, I had to trim a little off of the tip of the bracket to get it to slide through on my bike that has a CR500 motor installed in a CRF aluminum frame.

Share this post


Link to post
Share on other sites

I just installed a works connection skid plate on my CR250 and it took a little patience and fidgeting around to get the clamps in right. Start with the flat one first and then put in the ones with the hooks. Worked for me.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×