Jump to content
Sign in to follow this  

How do i take the TRS insert out?

Recommended Posts

Can some one help me out here? Do i just undo the allen screws and slide it out? I've never taken it apart before..

-patch

Share this post


Link to post
Share on other sites

You need to remove the end cap, remove the allen screws, from the can and it just sets in a counter bore. Then reinstall the end cap on the can. Power gains are minimal but noise is maximun.

Share this post


Link to post
Share on other sites

cool, ill see how it is.. so just pull every thing out? and put the cap on?

-patch

Share this post


Link to post
Share on other sites
cool, ill see how it is.. so just pull every thing out? and put the cap on?

-patch

Correct. IF, I remember correctly, The difference ( according to Eddie) Cork in to cork out = 2 main jet sizes @ sea level, with the full Ti system.

Share this post


Link to post
Share on other sites

Yea, I jetted mine to be uncorked, But never took it out, Seemed to run fine all this time, But maybe it'll run better now :-p and i ran it by him to make sure it'll but fine, so cross your fingers !

Thanks again.

-patch

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×