Jump to content
Sign in to follow this  

"S" Carb Float Level

Recommended Posts

What is the proper method to measure the float level in a "S" carb? Did some searching but couldn't seem to find an answer. I wanted to check as I have a bit of the off-idle bog with the 3x3 / Dynojet kit / "burned" suggested jetting and fuel screw setting method.

Thanks in advance.

Share this post


Link to post
Share on other sites

13mm + or - 1mm. It is measured at a bit of an angle. I turned mine horizontal with the float just barely seated to get a good measurement.

Share this post


Link to post
Share on other sites

Thanks, but my question was intended to understand the method of checking it.

Thanks again.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×