Jump to content
Sign in to follow this  

Front number plate pre printed puzzle

Recommended Posts

Ok, well I got some custom plates printed up, and they cost me a nice sum. How do I put these on the front plate without having to cut a hole in them to take em off if I need too. I fuigure I can put the plate on and then stick the graphics on on the bike so I didnt have to cut them, but I would have to to take the plate off, any other idea?

IMG_9825%20(Large)%20(Small).JPG

Share this post


Link to post
Share on other sites

ive seen a couple guys make slits instead of but the complete hole out. what i mean bye that is once its on the number plate, take a razor blade to the hole, and cut slits starting from the middle of the hole to the outside of it. that way theres nto part missing, but if you need to take it off, all you do is put the tool in there and it bends the flaps back.

Share this post


Link to post
Share on other sites

yea, obviously you would take a razor blade and cut slits into it, but doesnt that look bad after they are X'ed?

Share this post


Link to post
Share on other sites

no. if there smooth cuts, then you wont be able to tell that their there unles you push on it or open it up

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×