phillip screws in stator plate

[crwdirtyj]

how do you remove these to screws

[clev]

already in a pickle, huh?

[dirtbkr188]

With an impact driver and a hammer...

[NSANEMX]

Ok I will give you a tip --

# 1 go to a hardware store and buy some #2 and # 3 screwdriver bits try to find some that are not very pointed on the end and an extension that the bits will slide into also get yourself a 1/4 6 point socket that will fit over the bit make sure you have a ratchet for the socket

#2 find the bit that fits the best in the screws insert the bit and the extension and strike the end of the extension with a hammer being carefull to not hit it too hard and also not to hit anything but the extension

#3 slide the socket and ratchet on the bit and attempt to remove the screw

#4 if screw doesnt budge repeat the striking process

# 5 If available use an impact screw driver instead of the above tools but if your in a pich then the bit and extension will work fine if you do it correctly be carefull and wear a glove on the hand holding the tool being struck the better the bit fits the better your luck

[crwdirtyj]

impact driver and hammer worked real good now installing kitaco inner rotor

[clev]

impact driver and hammer worked real good now installing kitaco inner rotor

What is this...play by play?