Jump to content
Sign in to follow this  

tricks to rear wheel bearing removal?

Recommended Posts

Hello, have a xr250 and I can't get the sprocket side cover dealy off.

The thing with 4 little holes. How does this come off?

Thanks

Share this post


Link to post
Share on other sites

Not sure what the tool is called. But it is 2 pieces of metal held in place in the center and pivots. At each end is a piece of metal dowel.

Two of the dowels go into the opposite holes and you just turn it and the cap threads right off.

Hope I didn't lose ya.

Share this post


Link to post
Share on other sites

It threads out.

Here are some tool options:

1) Get the adjustable type wrench Zappa described from Honda.

2)Buy a socket type wrench like this

"MOTION PRO HONDA REAR WHEEL BEARING RETAINER TOOL Easily removes Honda CR, and XR rear wheel bearing retainer rings without damaging your hub.$34.95 "

3) Use a hammer and punch. You be the judge on this.

Share this post


Link to post
Share on other sites

OK now I understand. thanks very much for the help guys!!:applause:

Share this post


Link to post
Share on other sites

I used a key for taking grinder discs off. Was a bit of a pain but finnaly came loose:ride:

Share this post


Link to post
Share on other sites
I used a key for taking grinder discs off. Was a bit of a pain but finnaly came loose:ride:

Good job. I'll have to keep that one in mind.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×