Jump to content
Sign in to follow this  

Worst aftermarket part you ever bought.

Recommended Posts

boyesen accelerator pump cover. Does notta, I didnt buy, but I just know.

I have the Quickshot on my bike and it works great. Huge bottom end increase and no more bogging.

Share this post


Link to post
Share on other sites

A wet sump kit for 2002 Yamaha 250F. It did save weight (its intended purpose), but I was changing the oil almost every ride. Plus...because the '02s didn't have an oil cap on the engine casing, I had to add oil by removing a cap on the left ignition cover that is normally used for timing.

Share this post


Link to post
Share on other sites
boyesen accelerator pump cover. Does notta, I didnt buy, but I just know.

If you don't have one -you don't know

  • Like 1

Share this post


Link to post
Share on other sites
First a quickshot complaint and then Twin Air?

I definitly don't get you guys-both are very good products.

doesnt seal well at all on my crf250. Also the foam is way thinner than oem.

Share this post


Link to post
Share on other sites

Buying three different front sprockets for different conditions.

Oh yea, and my sons FMF fatty for his RM100. The pipe lasted one race

(no fault of FMF) and the bike he grew out of in less than one season.

Oh yea, and the extra levers, brakes, rear wheel etc...

If you have a young son into racing, after he wears the poop out of something get him a bigger bike. :applause:

Share this post


Link to post
Share on other sites
doesnt seal well at all on my crf250. Also the foam is way thinner than oem.

I've used them for years on different brands (and my old crf450) and never had any problems-maybe you got a bad one. The only one they have thats really thin is the backfire line-they are too thin for me to take a chance on. I like their standard filters.

Share this post


Link to post
Share on other sites
One of those goggle wiper things that you put over your finger...it fell off about 20 minutes into a harescramble.

had one that was sewn into the gloves, worked great on streetbike helmets, no clue on goggles.

Share this post


Link to post
Share on other sites

Grips that had CRF built into them (from ebay), they were so thick I could barely get my hands around them, and they looked really dumb. Also the Scott EFS battery powered roll offs from back in 87 or 88. They dispensed an entire roll of film as I was sitting on the line for my last 80 nov. moto at Ponca City Nats. in 89:banghead:

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×