Jump to content
Sign in to follow this  

How far to press swingarm bearings in????

Recommended Posts

I didnt pay attention when i took them out. I was wonding if they sit flush with the inside seal or if they are flush with the out side and then there is a gap between the seal and bearing. Thanks

Share this post


Link to post
Share on other sites

11-11.5 mm from the outer edge

You need to leave room for the thrust needle bearings, washers and seals.

Share this post


Link to post
Share on other sites

if I recall, there is a step in the bore from the outsite for the thrust washer to rest against. The bearing needs to be just past that so it doesn't interfere

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×