Knurling, Portland/Vanc. or close

[MXOldtimer]

Looking for a machine shop that does Knurling. For pressing in undersized stem in a T-clamp.

If you know of any or had this service done could you point me in their direction.

ThanX in advance.

.

[brewster]

Knurling is usually done on an outside surface, in this case, the stem. Any reputable machine shop should be able to do it for you.

What is the difference in diameters?

Ride on

Brewster

[MXOldtimer]

Knurling is usually done on an outside surface, in this case, the stem. Any reputable machine shop should be able to do it for you.

What is the difference in diameters?

Ride on

Brewster

Your correct, I guess I should read what I type. Took care of it.

[MXOldtimer]

What is the difference in diameters?

Ride on

Brewster

Actually I don't know yet until I receive my parts later in the week. I might not have to have the knurling done but, in case I do I'll be look'n for a shop. I was kinda hope'n someone might recommend in the mean time rather than shop'n around.

.

[brewster]

Something you might want to look into is the Devcon/Permatex Retaining compounds:

http://www.devcon.com/permatex.cfm

Ride on

Brewster

[Mr. Neutron]

Try Charlie Brown, at Superior Sleeve, in Clackamas OR. He races at our local vintage mx races, & knows a lot about biking/machining needs......

http://www.superiorsleeve.com/

[MXOldtimer]

Try Charlie Brown, at Superior Sleeve, in Clackamas OR. He races at our local vintage mx races, & knows a lot about biking/machining needs......

http://www.superiorsleeve.com/

Good one!

Thanks, I've been to Charlie's before and he's 20 min's from me.

.