Jump to content
Sign in to follow this  

crf crank question

Recommended Posts

i put new bearing in the cases and a new crank too. how much end play in the rod should i have?

Share this post


Link to post
Share on other sites

Chech the book. I don't have mine handy or I would check. Up and dowm there should be 0:thumbsup:

Share this post


Link to post
Share on other sites

sorry, i meant to say play in the crank. i can move it side to side in the cases and want to make sure there isnt too much play. anyone know the measurement for that?

Share this post


Link to post
Share on other sites
sorry, i meant to say play in the crank. i can move it side to side in the cases and want to make sure there isnt too much play. anyone know the measurement for that?

well,---it will move side to side quite abit untill you tighten down the rt PTO side crank gears and bolt to 90 ft lbs---,and that will pull the crank over to the rt and center it all up in the cases ,

then you should get just alittle or no side to side play when cold ,---with oil on the bearings and the cases all warmed up you will have no play side to side or any up and down at all ---:applause:

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×