Hi all, Going to be putting a Hinson clutch basket and new plates in my 06 450F this weekend. Although I have done suspension, valves and piston replacements before, I have never done clutch work. I have the common tools (torque wrench, etc), and the service manual, but am just looking for any "tribal knowledge" from the more experienced. Such as: Do I have to replace the lock washer with a new one? Looks like it will be a week or so to get a new one? Is all the mounting hardware standard thread (i.e. nothing to turn to the right to loosen, etc)? Is the "special clutch tool" shown and used in the manual a must have? I think I've read some about having to drill out some rivets that are holding the stock basket on? Is that correct or did I miss-read something. Any type of special break-in procedure? I have been told that soaking everything in oil overnight before installing helps seat the clutch initially. Anything else anyone has to offer will be greatly appreciated.