Jump to content
Sign in to follow this  

Carb tear down.

Recommended Posts

Hey all

About to pull my carb apart (first time). Ready to give her a good clean out and check for wear. Is there any tip you all have on this procedure ?

Also I hear a few people talking about reseting Float etc. Will this be necessary and if so how is it done ?

Cheers in advance

Share this post


Link to post
Share on other sites

Yes, make sure you press super hard on those phillips heads when you take them out, if you slip and grind once, you'll never get it out without grinding a flat head into the screw head.

Replace with metric allen heads, make sure they're long enough and the right pitch. One of mine wasn't long enough and it started to strip out.

Also, pay attention when taking out the slide linkage shaft, it's a little goofy and it took me 30 minutes to get it right again. As for the float height, if it's not spilling over, dont do anything.

It's really easy once you see everything out.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×
×
  • Create New...