Hey TTer's. I have a problem. Need you help. I have approximately 30hrs on my bike. I checked the valve clearance for the first time today. All exhaust were @ .22mm and two intake were @ .12 mm. One intake was tight and out of spec. A .102 mm would not fit and a .078mm fit but was very loose. I don't have a feeler between the two measurements. I'm guessing the valve clearance @ .09mm. Has anybody else had problems with the 07 valves being tight? Now I'm worried about the valve that was tight. I had a 426 for 5 years and the valves were never out of spec. Should I just reshim and not worry about it. Could the valve be damaged? Can I just remove the intake cam and reshim without removing the exhaust cam since they were in spec? So what do you think?