Jump to content
Sign in to follow this  

RS-3 RS-2 end caps ???

Recommended Posts

I am pretty sure you can't, the RS-3 can is round and the RS-2 can is tri-ovale. I don't know how you would get two dissimilar shapes to mate-up right, and I don't even think you can just buy an end cap. Have you tried calling Yoshimura at (909) 628-4722 or sent them an email at http://www.yoshimura-rd.com/Contact_Us.aspx yet? I think they would be the better people to ask this question to.

Share this post


Link to post
Share on other sites
I am pretty sure you can't, the RS-3 can is round and the RS-2 can is tri-ovale. I don't know how you would get two dissimilar shapes to mate-up right, and I don't even think you can just buy an end cap. Have you tried calling Yoshimura at (909) 628-4722 or sent them an email at http://www.yoshimura-rd.com/Contact_Us.aspx yet? I think they would be the better people to ask this question to.

look here is a RS-2 its the same as the RS-3 and i did email yosh thanks

Share this post


Link to post
Share on other sites

My mistake, I though that the RS-3 was round, it is obviously oval. The RS-2 is also oval but it bulges out on the sides like a diamond with no points hence the tri-oval. As far as I can tell after watching that video and looking at my RS-2 the cans are slightly different. My camera battery is dead right now but I will try to post a picture of it later. I hope my description makes sense and helps you out.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×