Jump to content
Sign in to follow this  

Power Curve Question

Recommended Posts

I have a question about the power on my DRZ.

My setup is stock other than the TT FCR39 (jetted as per instructed by Eddie) and a FMF full exhaust (Powerbomb header and Powercore4).

I have power (torque I imagine) down low and power up at the top of the RPM but there is a slight lag in the middle as the bike picks up speed. I am wondering if anyone had a suggestion to improve the midrange.

No I cant loose any more weight.

Thanks in advance.

Share this post


Link to post
Share on other sites

you need better cams the S?SM cams are for passing emitions

on my SM I have the stock "junk" carb with re-jeting 3x3 and pipe ... whin I added the "E" cams the tork curve smoothed out and became far more fun to ride

the "E" cams I got off Ebay for $100 ... aney more than that your getting ripped off

if your buying new get the hot cams

Share this post


Link to post
Share on other sites

If its similar to what mine did, It feels like it goes Flat, then picks up correct..I raised the needle 1 notch & that corrected it. Mine was a Tad Lean.

Share this post


Link to post
Share on other sites
To raise the needle up I move the clip down one notch?

Yep:thumbsup:

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×
×
  • Create New...