Jump to content
Sign in to follow this  

Need a place to start! YZ250F/Utah

Recommended Posts

I just picked up a yz250F that has some mods done to it. As far as the motor goes, it has a an overbore kit installed (cylindar bore is 2mm over, now 79mm) with a high compression wiseco piston. The bike also has a gytr titanium oval muffler.

I need some advice on jetting for this bike. I normally ride 2 differant sets of elevations, 3500-5500, and 6000-9000. I know these are huge elevation changes, but thats what ya get riding in the mountains of northen utah...

Does anyone know a place to start for both these eleavtions, and then I can fine tune from there.

thanks guys!

Matt

Share this post


Link to post
Share on other sites

Lot's of YZ info on this forum if you do a search. I have a 06 WR250F needle clip 2 from top, 160 main, 60 leak, 40 pilot, fuel screw 1 turn out. Runs sweet @ 6,500 -9,000.

That should at least get you started...I have the same altitude issues in CO. Looking fwd to fuel injection.

Share this post


Link to post
Share on other sites

Yea, i just started riding out here and efi would be so sweet for this neck of the woods...

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×
×
  • Create New...