Jump to content
Sign in to follow this  

A question regarding the JD Kit

Recommended Posts

Hey,

in a few days I'm about to put a Keihin FCR MX on my ol' 1996 610 and was intending to put the JD kit on it, but not sure which one. I reckon the most similar engine is the SMR 610 (is SM 610 R ?? ) so should I take that one?

A bit of a weird combination but I hope I can work something out from JD's kit even with my bike? If I'm not mistaken SM 610 has same engine as TE 610...

Thanks

  • Like 1

Share this post


Link to post
Share on other sites

Dobar dan Quantum, kako si?

What elevation are you at? Knowing that will help when fine tuning the carb :)

Share this post


Link to post
Share on other sites

Hi ... odlično sam! :)

Elevation is 583 feet, I just looked into the map.

BTW, just to make sure everyone understood me right - not asking for jetting info (yet) just asking

which kit do I buy, the one for the 510 or the SMR 610?

Contacted JD but no response so far.

Share this post


Link to post
Share on other sites

You can find out in google earthview, or just PM me where you live & I'll do it for you :)

Share this post


Link to post
Share on other sites

Anything else that is needed? Humidity is about 46% outside right now, temps peak out at 100°F.

The carb I bought comes with a

170 Main Jet

42 Idle (or pilot)

55 AP Jet (or leak jet)

72 Choke Jet

My Dell'Orto is jetted as

170 Main Jet

50 Idle

35 AP Jet

45 Choke Jet

I reckon the only thing I'll need to replace is the choke jet, that is if the AP isn't gonna bog due to lack of squirt.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×
×
  • Create New...