Jump to content
Sign in to follow this  

Jetting Specs? JD jet kit - 2003 DRZ400E

Recommended Posts

2003 E model

Just ordered the JD jet kit

Bike is all stock except for HMF slip on exhaust

Live in North NJ.

I havent done the 3x3 yet, but plan to when the kit comes in.

And advice on Jetting specs? or just follow the recommended specs when i get the kit?

Share this post


Link to post
Share on other sites

I just re-jetted my 2003 E with a White Brothers R4 slip on and snorkel removed (same as 3x3 just easier/reversible). Everything else is stock. I didn't use a kit I just went with the factory jets and recommended settings I found here while searching.

165 main jet

48 pilot jet

5th clip slot on stock needle (down one notch from stock)

Air/Fuel screw @ 2.5 turns out from close

Works very nicely here at 900ft elevation :)

Good luck!

Share this post


Link to post
Share on other sites
2003 E model

Just ordered the JD jet kit

Bike is all stock except for HMF slip on exhaust

Live in North NJ.

I havent done the 3x3 yet, but plan to when the kit comes in.

And advice on Jetting specs? or just follow the recommended specs when i get the kit?

follow the directions in the kit.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×
×
  • Create New...