Jump to content

Cam or Pipe?


Recommended Posts

Cam will probably give you more bang for the buck although I'm not sure I'd go with a hot cam. Sounds like Crower or Williams has some good cams. If you're going for a pipe you should look at the MRD stuff also, you might be able to get a cam and a pipe sinc the MRD stuff is a lot more affordable.

Link to comment
Share on other sites

Done both ... what exactly are you looking for??? Low, mid or top end??

In general, the cam is the most bang for the buck, but if its low end you want, and money is an issue, I would recommend:

1. Hotcams Stage1 cam (check ebay $120 range)

2. MRD torque header (just the header pipe .. not the cam . $150)

You can get BOTH for probably cheaper than the Pro Circuit exhaust ... if LOW END is what your after 🙂

I have them both on my wifes bike (see garage) and also have the MRD can.

Good luck :D

Link to comment
Share on other sites

with just the right cam our bikes get another 1.5 hp and almost 2 ftlbs of bottom torque at 7000 rpm! and the throttle response and carburation improves with it a lot.... takes away reversion in the intake which helps get rid of the bog under 5k rpms. mucho good

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

×
×
  • Create New...