Jump to content
Sign in to follow this  

ok got my carb off & apart...HELP

Recommended Posts

took off my fcr carb, it wouldn't idle right(hanging up)& breaking up at high rpm's in 1st & 2nd...couple questions:

should I put any wd-40 in the top where the rollers are they seem to stick now

here's my #'s(I'm not sure what their called)

the pin is OBDXP there's 7 slots & it's in the middle

the 3 jets in the bottom are

45 this is the recessed jet

142 this is where the pin goes thru

65

the 2 jets on the side are

60

200

and the screw on the bottom doesn't have a # & it was turned out 1-1/4 turns

any advice or input would be cool

should I post this in the jetting section?

Share this post


Link to post
Share on other sites

make the sure the slide plate is square end down.

change the 142 main jet to a 160.change the 45 pilot jet to a 48.move the clip on the needle from 4 to 5.

set the fuel screw at 1.5 turns.

wd-40 is fine for lube.

Share this post


Link to post
Share on other sites

I didn't take the slide plate out(should I have?)

5 is counting from the top?

I'm running a cr83 plug will this still be good?

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×
×
  • Create New...