Jump to content
Sign in to follow this  

question on internals of stock forks?

Recommended Posts

got a 01 yz426 that i know the front end has been lowered and im replacing the seals i figured i might as well take it back to stock as i could use the extra ground clearance since im really gettin tired of getting hung up on trees, i know the springs are shorter then stock for sure so those are getting replaced with a extra set of stock ones i had lying around, but i also pulled the damper rod assembly apart where just above the shim stack was the normal spring(bottoming spring or somethin i think its called) then i would say a 2" nylon orange spacer, im assuming this is to limit the free length of the fork correct? i will need to remove this to get my full travel again correct? i would post a pick but my cameras broke, and tried finding it on some parts schmatics but aparently were not suppose to go this deep into out front end?! thank in advance.

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

  • Create New...