Jump to content
Sign in to follow this  

re position the fuel tube going into the carb?

Recommended Posts

can the tube that takes the fuel line in be rotated? I want to move it to about the 10'oclock position when I use my 6.6 gallon acerbis tank. .... and back again when I go back to the stock tank.

this is on a yamaha 2003 wr250f

fuellinein.jpg

Share this post


Link to post
Share on other sites

its press fit.

ive had some success turning them by heating the carb body with a heat gun and using a good set of small vise grips on the base of the fitting.

that being said ive also ruined a few carbs.

be very careful.

Share this post


Link to post
Share on other sites
its press fit.

ive had some success turning them by heating the carb body with a heat gun and using a good set of small vise grips on the base of the fitting.

that being said ive also ruined a few carbs.

be very careful.

I take advise from an expert very seriously ....

I think I'll pass on this for now!

I can't afford to ruin my carb.

but its nice to know it's a press fit item,

and doesn't have some kind of retaining tab/notch ......

thanks for the advise!

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×