Jump to content
Sign in to follow this  

Magura Clutch 09 crf450

Recommended Posts

No, the routing of the clutch cable now goes around the back of the motor as opposed to the side. However the 450x magura might work as its also routed this way.

Share this post


Link to post
Share on other sites

I put one on my bike last weekend and love it...The clutch i bought was made for a 09 450..

Share this post


Link to post
Share on other sites

Thanks for the replies guy

450fguy where did you get the kit and would ya stuick up a picture of it

i have one for the 02-08 450 might try adapt it to fit with new parts

they are one of the best mods you can make to a crf

Share this post


Link to post
Share on other sites

the 05-08 will work, you just need to get a longer bolt that holds the the bracket to the case. Also grab about 8 washer so the bracket can be spaced out. I would recommend getting a stainless steel line though as the routing passes right by the pipe. ( I melted my stock line)

Share this post


Link to post
Share on other sites

Call Magura and get the 09 Bracket. Most all there units are the same. Its the brackets that make the model specific fitment possible.

Share this post


Link to post
Share on other sites

i've emailed them so hopefully its just a bracket i need

the clutch fades so easy on the 09 with little use!

might have to go the hinson route too

Share this post


Link to post
Share on other sites

yes..the unit looks likes the one i put on my 08....on the 09 you use the stock bracket but it comes with a spacer that goes between the engine case and the stock bracket..you also of course need a longer bolt....

I just checked and they have them in stock at Rocky Mountain online

Share this post


Link to post
Share on other sites
I put one on my bike last weekend and love it...The clutch i bought was made for a 09 450..

What was it that you loved? Did make the clutch pull easier?

Share this post


Link to post
Share on other sites
$30 for the bracket to adapt my 08 magura to the 09 bike

not to bad

Let us know how you like it on your 09!

Share this post


Link to post
Share on other sites

will do man

the standard clutch is muck it fade even it you look at it

anyone installed the full Hinson Set up yet

anyone find the bike very easy to stall even with the tickover at 1800rpm

Share this post


Link to post
Share on other sites

With the RPM's increased, the bike has barely stalled. It really helps.

Share this post


Link to post
Share on other sites

alright lads i ordered the bracket off magura and it arrived yesterday

its a bit of a job to route the line securly and outt of harms way but nothing too difficult

boy does it make some differance

clutch pull of a cr80:thumbsup:

akso got the master cylinder top with no hot start lever for the factory look:ride:

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×