Jump to content
Sign in to follow this  

Power Valve Cover

Recommended Posts

I started my bike the other day and noticed it was smoking quite a bit down around the engine. I looked around and noticed that the power valve cover had about a CM gap between it and the engine. Apparently the bolts vibrated loose while I was riding.

My question is what all do I need to do? Do I just replace the bolts and tighten it down? Do I clean it up really good, etc?

Share this post


Link to post
Share on other sites

i would remove the cover clean the gasket off of the cover and cylinder, clean really well and remove all oil and then replace the gasket and put the bolts back with lock tight and torque to speck.:lol:

  • Like 1

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×