Jump to content
Sign in to follow this  

FCR help please Eddie

Recommended Posts

I've searched and i did follow the how to for install and o-ring mod. Jetted accordingly

sea level,aftermarket pipe with open muffler-

160 main jet

200 main air jet

EMN needle

clip 3

45 pilot jet

remove pilot air jet

2 turns fuel screw

o-ring mod

I bought the FCR off my buddy who is selling his DRZ. He bought it off of TT just last summer. I was hoping my problem was the Zip ty fuel screw he installed, after i did some research on that, so today i installed the stock fcr screw at 2 turns out and still have the very bad hanging idle, tons of popping on decel, and slight delay when turning the throttle. Throttle wheel is not hitting the frame and the 3x3 is a 3x3. Can somebody please help me out here. I've attached videos and pictures so i can get the best help possible. Bike was warmed up.

th_FCR004.jpg

th_FCR005.jpg

FCR001.jpg

FCR002.jpg

FCR003.jpg

Share this post


Link to post
Share on other sites

Oh yeah there is the chopped RS2 for you guys who want to see and hear it. :p

Share this post


Link to post
Share on other sites

Yes pump was squirting when i turned the throttle wheel before install

Share this post


Link to post
Share on other sites

I just took it for a cruise and head pipe was glowing. Bigger main?

Share this post


Link to post
Share on other sites

you were riding it at wide open the throttle and the header was glowing??

did you tune the idle down like i said?

Share this post


Link to post
Share on other sites

No that was right after i pulled back into the driveway, so i guess its not the main. I did turn the idle down but it wouldn't stay running much below whats in the video.

Share this post


Link to post
Share on other sites

No i didn't take the slide out

Share this post


Link to post
Share on other sites

No but i confirmed with him. I suppose the next step is to see if the jets are clear? I just really didn't wanna struggle taking that thing out and putting it back in again.

Share this post


Link to post
Share on other sites
No but i confirmed with him. I suppose the next step is to see if the jets are clear? I just really didn't wanna struggle taking that thing out and putting it back in again.

:p could of had it out 10 times over by now.

Share this post


Link to post
Share on other sites

Slide was upside down, thanks Eddie. So do i ask my buddy if he's retarded or was it assembled that way at the factory?

Install went much smoother the second time around. Didn't struggle nearly as much with air boots, throttle cable and such.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×