Jump to content
Sign in to follow this  

new reeds in 02 ktm 200exc

Recommended Posts

I just bought some boyeson reeds for my bike. When I was installing them I noticed as soon as I tighten the screws holding the reeds to the reed block the reeds pull away from the reed block on the opposite side. I have never installed reeds before and was wondering if any one had any ideas where the problem is, the new reeds or does my reed block need to be replaced? Any help is good help. thanks

Share this post


Link to post
Share on other sites

try swapping them side to side and flipping them over too. Should be almost a tight seal, perfection isnt very likely, you will probly be able to see a slight gap..

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×