Jump to content
Sign in to follow this  

Headlight Aimed Too High, Check The Wiring

Recommended Posts

I am in the process of adding a high/low/off switch in for the headlight. Cutting Torch mentioned on another thread the stock headlight is wired to the high beam(Red Black wire). This was true on my bike, but the owners manual shows the stock power wire going to the low beam! My wire layout is also different than the manual. I almost reversed the High/Low beams. You can change the beam pattern by simply pulling the male terminal on the bike side(Red/Yellow wire), and matching it to the low beam(Red/Yellow wire) on the headlight. I used a small pick to remove the terminal. The change in beam direction is noticable.

Share this post


Link to post
Share on other sites

Another thing to note is that the adjustment screw is alot longer than the adjustment spring. A longer spring or another additional short spring would help the adjustment screw work properly.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×