Jump to content
Sign in to follow this  

98 cr80 falling on its face when taking off???

Recommended Posts

I have a 98 cr80 that i recently purchased. It was running good, than it starting acting like it needed a new set of rings, so i replaced the top end, the cylinder was a little shiney on the bottom exhaust side. When it feels like it doesn't have any snap and when i let out the clutch it usually just bogs out. i know its a little rich, but i dont think it would make such a drastic and sudden difference like it did. any ideas?

Share this post


Link to post
Share on other sites

yeah, i did every air fuel trick i could imagine. after its been sitting it will start and run for a couple of minutes, then just not want to run anymore. The closest guess that i have come up with is a head gasket or a head. after pulling stuff apart last night, i think i'm getting a little water in the cylinder.. you ever had this problem?

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Reply with:

Sign in to follow this  

×